Thomas Buses - Allison Transmission Wiring Modification

Thomas Buses are driven by an Allison MD 3000 Series Automatic transmission. This 1995 Saf-t-liner model had no power to the operators trans shift pad. The shift pad is also the Trans ECU [electronic control unit] so as I have said before always check the source , in this case the batteries.

There was a power feed open between the batteries and the rear control box at the engine compartment. I was able to limp the bus home by jumping battery power to the terminal board inside the control box which goes to directly to the operators cab supplying battery power to the shift pad/ECU.

This is obviously how I determined the open from the battery to the control box/terminal board [standard wiring on all Saf-t-liners]. The code for this fault is 35-00 [push both arrows on the shift pad at the same time with key on to retrieve code {under normal circumstances}

The control box at the engine compartment houses the engine intake heater components, lights etc. as well as the main battery power to the front electrical control box below the driver's side window.





My plan is to totally bypass the trans battery supply circuit from the battery to the ECU. Here you can see I've already cut the wires [larger #8 guage pos. and neg. wiring come from the battery while the smaller #10 guage pos. and neg. wires are running up front to the ECU]




This is the terminal board I mentioned earlier, factory wiring with spade connectors that connect the battery feed wiring to the trans. ECU wiring.

The first picture [top] shows the #8 pos. and neg. wires hooked up and running directly to the trans ECU. This will eliminate the extra #10 wires shown in the rear control box.


In the drivers cab the rear cover has been removed for easy access to the back of the trans. ECU. The upper plug can be removed and inspected for battery power. Both pos. and neg. #18 wires [2 each] run into this plug directly from the battery. The #8 wire is downsized under the dash to accommodate the smaller wiring into the ECU plug-in.



The 12V source from the battery is shown here with no connections in between. With a Digital Multimeter you can check for a battery voltage and a good ground.






So now you know when you have a shift pad with no reading [key on] the first thing to check is the battery voltage.

I hope this has helped you become more familiar with Thomas Buses equipped with Allison MD 3000 Series Automatic Transmissions.